Remote Control - Q-See QSTD2404 User Manual

QSTD2400 Series DVR User's Manual

2.4 Remote Control

The remote control uses two AAA size batteries and works after loading batteries
as follows:
STEP1 Open the battery cover of the Remote Control
STEP2 Insert batteries. Please make sure the poles (+ and -) are correct
STEP3 Replace the battery cover
Notice: If the remote control does not work, check the following:
1. Check the poles of the batteries.
2. Check the remaining charge in the batteries.
3. Check to see if the sensor on the remote or the DVR is blocked or dirty.
If it still does not work, Please contact Q-See to get a new remote control.
The layout of the remote control is shown in Fig 2.10 Remote Control
Item Name
1 Power Button
2 INFO Button
3 REC Button
4 Number Buttons
5 Multi Screen Button
6 SEARCH Button
7 MENU Button
8 ENTER Button
9 Direction Button
10 +/- Button
Playback Control
11
Button
12 AUDIO Button
13 Auto Dwell Button
14 BACKUP Button
15 PTZ Control Button
Fig 2.10 Remote Control
Function
Soft off switch to stop firmware running. Push it before
powering off the DVR.
Get information about the DVR like firmware version,
HDD information
To record manually
Input numbers or choose cameras
To choose multi screen display mode
To enter search mode
To enter menu
To confirm the choice or setup
Move cursor in setup or pan/tilt/zoom (PTZ)
To increase or decrease the value in setup
To control playback, Fast forward/rewind/stop/single
frame play
To enable audio output in live mode
To enter auto dwell mode
To enter backup mode
To control PTZ cameras:
Move camera/ZOOM/FOCUS/IRIS/SPEED control
9