Netopia Firmware 4000-Series Software Manual page 273

Enabled:
Forward:
Call Placement/Idle Reset:
Source IP Address:
Source IP Address Mask:
Dest. IP Address:
Dest. IP Address Mask:
Protocol Type:
ADD THIS FILTER NOW
This pop-up menu allows you to configure what action will be taken for packets that the filter rule specifies
should be forwarded.
■ If you set Call Placement/Idle Reset to No Change (the default), no change will be made to the call
filtering attribute associated with the packet. If no other filter rule with its Call Placement/Idle Reset pop-up
set to Disabled previously has been or subsequently will be applied to the packet, the packet will be
forwarded as usual. No special action will be taken.
If the connection is up, the connection's idle timer will be refreshed and the packet forwarded as usual. If
the connection is down, the packet is queued until a connection is established.
■ If you set the Call Placement/Idle Reset to Disabled, the call filtering attribute associated with the packet
will be set such that the packet will be dropped if the connection is down, and forwarded without resetting
the idle timer if the connection is up.
Add Output Filter
+-----------+
+-----------+
| No Change |
| Disabled
+-----------+
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
ANY
CANCEL
|
Security 10-49