Netopia Firmware 4000-Series Software Manual page 260

10-36 Firmware User Guide
Enabled:
Forward:
Call Placement/Idle Reset:
Force Routing:
Gateway IP Address:
Source IP Address:
Source IP Address Mask:
Dest. IP Address:
Dest. IP Address Mask:
TOS:
TOS Mask:
Protocol Type:
ADD THIS FILTER NOW
Return/Enter to add this Filter to the Filter Set.
Enter the packet specific information for this filter.
Note:
Default Forwarding Filter
If you create one or more filters that have a matching action of forward, then action on a packet matching none
of the filters is to block any traffic.
Therefore, if the behavior you want is to force the routing of a certain type of packet and pass all others through
the normal routing mechanism, you must configure one filter to match the first type of packet and apply Force
Routing. A subsequent filter is required to match and forward all other packets.
Management IP traffic
If the Force Routing filter is applied to source IP addresses, it may inadvertently block communication with the
router itself. You can avoid this by preceding the Force Routing filter with a filter that matches the destination IP
address of the router itself.
Add Input Filter
Yes
Yes
No Change
Yes
127.0.0.3
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
16
16
ANY
CANCEL