Netopia Firmware 4000-Series Software Manual page 126

4-24 Firmware User Guide
In the Display/Change Filter Set screen select Display/Change Output Filter.
Display/Change Output Filter screen
+-#----Source IP Addr----Dest IP Addr------Proto-Src.Port-D.Port--On?-Fwd-+
+-------------------------------------------------------------------------+
| 1 0.0.0.0
| 2 0.0.0.0
|
+-------------------------------------------------------------------------+
Select Output Filter 1 and press Return. In the Change Output Filter 1 screen, set the Protocol Type and
Destination Port information as shown below.
Enabled:
Forward:
Source IP Address:
Source IP Address Mask:
Dest. IP Address:
Dest. IP Address Mask:
Protocol Type:
Source Port Compare...
Source Port ID:
Dest. Port Compare...
Dest. Port ID:
Select Output Filter 2 and press Return. In the Change Output Filter 2 screen, set the Protocol Type to allow
GRE as shown below.
Enabled:
Forward:
Source IP Address:
Source IP Address Mask:
Dest. IP Address:
Dest. IP Address Mask:
Protocol Type:
0.0.0.0 TCP
0.0.0.0 GRE
Change Output Filter 1
Yes
Yes
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
UDP
No Compare
0
No Compare
5150
Change Output Filter 2
Yes
Yes
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
GRE
NC =1723 Yes Yes |
-- -- Yes Yes |
|