Setting The Feed Dog; Setting The Feed Dog Position - DURKOPP ADLER H-Type 969 Service Instructions Manual

Setting the feed dog

8
The position and the movement of the feed dog and needle bar have to be
coordinated so that the needle pierces exactly in the center of the needle
hole on the feed dog.
Sequence
First, check the following setting:
• Needle bar linkage ( p. 47)

8.1 Setting the feed dog position

Proper setting
When the stitch length is set to 0 and the needle is at the bottom dead
center:
 The center of the feed dog opening (2) lines up with the axle of the
Cover
• Tilt the machine head ( p. 10).
Service Instructions 969 - 01.0 - 12/2015
Setting the feed dog
WARNING
Risk of injury!
Crushing injuries from moving parts.
Switch off the machine before setting the feed dog
position.
needle.
39