Basic Setting Of The Thread Cutter - DURKOPP ADLER H-Type 969 Service Instructions Manual

3. Tighten the screw (1).
4. Loosen the screw (4) and set the handwheel to a scale position of 120°.
5. Move the control cam (3) to a distance of 1 mm from the lever (2), man-
6. Tighten the screws (4).

14.2 Basic setting of the thread cutter

Proper setting
When the stop lever (6) is touching the base plate (5) of the machine:
 The distance between the control cam (4) and the roller (1) must be
 The piston of the pneumatic cylinder must be 0.5 to 1 mm from the
Cover
• Upper right cover ( p. 11).
• Tilt the machine head ( p. 10).
Fig. 53: Basic setting of the thread cutter
①
②
③
④
(1) - Roller
(2) - Gage
(3) - Upper lever
(4) - Control cam
76
ually press the lever down and manually rotate the control cam until the
pulley (7) engages in the setting groove (6).
0.1 to 0.2 mm.
base of the cylinder (it must not be touching it).
Adjusting the thread cutter
⑤
⑥
(5) - Piston
(6) - Shaft
(7) - Screw
(8) - Screw
Service Instructions 969 - 01.0 - 12/2015
⑧
⑦