Adjusting the thread cutter
14 Adjusting the thread cutter
14.1 Adjusting the thread cut-off point
Proper setting
The left edge of the lever (2) must be at a distance of 81.5 mm from the
right edge of the arm (5). The control cam (3) is located at a distance of
1 mm from the lever (2).
When the pulley (7) is engaged in the setting groove of the control cam (6):
The handwheel scale indicates 120°.
Cover
• Upper right cover ( p. 11).
Fig. 52: Setting the position of the lever using the pulley and the control cam
①
②
③
④
⑤
Setting steps
1. Loosen the screw (1).
2. Adjust the lever (2) to a distance of 81.5 mm from the right edge of the
Service Instructions 969 - 01.0 - 12/2015
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
sharp and moving parts.
Turn off the machine before setting the thread
cutter.
81.5 mm
1 mm
(1) - Screw
(2) - Lever
(3) - Control cam
(4) - Screws
arm (5).
(5) - Edge of the arm
(6) - Setting groove
(7) - Pulley
⑦
⑥
75