Table of Contents
Advertisement
• When connected to the 3D Sync Transmitter, the built-in 3D Sync Transmitter feature of the unit
will turn off. You cannot use both at the same time.
Connecting a USB cable
If using a commercial optical fiber HDMI cable, etc., which needs a power supply, use a
USB cable to supply the power.
Tips
• For details on the output specification of a USB connector, see "Specifications" (1 page 66).
• Power is not supplied during standby mode.
Notes
• The USB connector of this unit is for output only. Do not connect the unit to a USB port of a PC
etc.; it may cause a malfunction.
• Sony is not liable for loss of data or failure of a device arising from a USB connection with the unit.
• Before using, read the manual of the device to be connected.
• Before using, be sure to check the rated voltage and current of the device.
• For safety, if the input current is higher than the rated current, the output voltage of the unit may
temporarily shut down.
Right side of the unit
Optical fiber HDMI cable with connector for
USB power supply (not supplied)
19
Advertisement
Table of Contents
