Cable Or Antenna; Cable And Antenna; Connecting A Cable Box; Cable Box And Cable - Sony KP-43T75 Operating Instructions Manual

C
75-ohm coaxial cable
(Rear
of
• VHF --_="=!
projection TV)
and __
EAt-66 U/V mixer
•
UHF
{ tl (not supplied)
300-ohm twin lead cable
Cable or antenna
This is the simplest connection. Connection is
made directly from the cable or antenna to
the projection TV.
Coaxial cable
(Rear of projection TV)
VHF/UHF
Cable and antenna
You may find it convenient to use the
following set up if your cable provider does
not feature local channels that you are able to
receive using an antenna.
(Rear of projection TV)
Coaxial cable AUX
(No connection "TO TO CONVERTER
CONVERTER" in this case)
Antenna cable • VHFIUHF
Select Cable or ANT mode by pressing ANT
on the remote control.
Connecting a cable box
Some pay cable TV systems use scrambled or
encoded signals that require a cable box* to
view all channels.
Also, set "Cable" to "On" in the Channel Set
Up menu (page 31).
(Rear of projection TV)
Coaxial cable VHFIUHF
IN _ OUT
*Cable box
Cable box and cable
Some pay cable TV systems use scrambled or
encoded signals requiring a cable box* only for
certain channels (e.g. HBO, SHOWTIME, etc.)
*Cable box
(Rear of projection TV)
AUX
Scrambied (K)_
channe s TO CONVERTER
....
75-ohm coaxial cable i (Signal)
(not suppliedl
i
VHF',/UHF
CATV cable :_ '_i_
(unscrambled channels)
For this set up, you can switch between
scrambled channels (through your cable
box), and normal (CATV) channels by
pressing ANT on your remote control.
Notes:
• You may be able to program your Sony
remote control to operate your cable box.
(see "Operating a Cable Box or Satellite
Receiver (SAT)" on page 49)
• During PIP or Favorite Channel viewing,
the AUX input can only be viewed in the
main picture.
9