Turning Off The Power; Projecting High-Resolution Images; (V Split Display) - Sony VPL-gt100 Operating Instructions Manual

Turning Off the Power

1
Press the ? / 1 (ON/STANDBY)
button.
A message "POWER OFF?" appears on
the screen.
2
Press the ? / 1 (ON/STANDBY)
button again before the
message disappears.
The ON/STANDBY indicator flashes in
green and the fan continues to run to
reduce the internal heat. First, the ON/
STANDBY indicator flashes quickly,
during which you will not be able to
light up the ON/STANDBY indicator
with the ?/1 (ON/STANDBY) button.
The fan stops and the ON/STANDBY
indicator changes from flashing green to
remaining red.
The power is turned off completely, and
you can disconnect the AC power cord.
Note
Never disconnect the AC power cord while
the indicator is flashing.
You can turn off the unit by holding the ?/1
(ON/STANDBY) button for about 1 second,
instead of performing the above steps.
Projecting high-
resolution images (V
Split display)
Signals transferred after an image is split at
"4096 × 2160" or "3840 × 2160" resolution
are projected.
1
Connect DisplayPort output 1
and DisplayPort output 2 of the
workstation to DisplayPort input
1 and DisplayPort input 2 of the
unit respectively (1 page 16).
2
Turn on the unit and
workstation.
3
Select DisplayPort 1 (or
DisplayPort 2) in the input
palette.
4
Select either "2048 × 2160" or
"1920 × 2160" resolution in the
setting screen on the
workstation*.
5
Select 60Hz for the refresh rate.
* For information on the setting screen,
as operation differs depending on the
OS or the graphic boards which are
installed in the workstation, consult
with the manufacturer of the
workstation or graphic boards.
If "2048 × 2160" or "1920 × 2160" signals
are input via DisplayPort input 1 and
21