Table of Contents
Advertisement
3D video images
Symptom
The video image does not
seem like 3D video images.
Others
Symptom
The fan is noisy.
The lens shift cannot be
adjusted.
The unit and connected
equipment turn On/Off,
play back, and operate at
the same time.
Cause and Remedy
c Check if the 3D glasses are turned on (1 page 23).
c Make sure that the battery in the 3D glasses is charged.
c Check if the input source is HDMI.
c Set "2D-3D Display Sel." to "Auto" or "3D" (1 page 42).
c Check if the input signals are compatible 3D signals (1 page
72).
c If no 3D signal is input from the 3D equipment connected to the
unit, restarting the connected 3D equipment may solve the
problem.
c When the viewing or projector position is too far from the
screen, the 3D glasses may not be able to display the images
properly (1 page 24).
c If you use the optional 3D Sync Transmitter, check that it is
placed within the specified range (1 page 18).
c The screen size is not appropriate. Set the zooming
magnification to low or watch the image from farther away from
the screen (1 page 78).
Cause and Remedy
c Check the setting of "High Altitude Mode" on the Setup
menu (1 page 40).
c Make sure that the room temperature is not too high.
c Check the installation conditions (1 page 8).
The number of fan rotation increases to maintain the product
reliability of the projector's components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
c The lens shift cannot be adjusted over the range of movement.
Adjust the lens shift within the range of movement (1
pages 14, 77).
c "Control for HDMI," "Device Auto Power Off," and "PJ Auto
Power ON" are set to "On." Set them to "Off."
For details, see "HDMI Setting" (1 page 43).
59
Advertisement
Table of Contents
