Table of Contents
Advertisement
Portrait Mode
Standby Mode
Power Saving
Lamp Setting
You can set this mode according to the type of installation.
On: Use this setting for a wall installation (1 page 8).
Off: Use this setting when using the unit horizontally, or ceiling
mounted.
Note
If you use the unit with improper settings, an internal malfunction
may occur.
You can select the power consumption in standby.
Standard: The power consumption in standby mode is normalized.
Low: The power consumption in standby mode is lowered.
Tip
When this item is set to "Low," the "PJ Auto Power On" function is
disabled (The function is set to "Off" and does not appear in the
menu). The network function is also disabled in standby mode.
Sets the power saving mode.
Lamp Cutoff: If no signal is input for 10 minutes, the lamp turns off
automatically and power consumption is reduced. If signal is
resumed, or any button on the control panel or remote control is
pressed, the lamp will light again. In Lamp Cutoff, the ON/
STANDBY indicator lights in orange. (1 page 4)
Standby: If no signal is input for 10 minutes, power is turned off
automatically and the projector goes into standby mode.
Off: The power saving mode is released.
When replacing the lamps, set the desired lamp setting
(1 page 64).
41
Advertisement
Table of Contents
