Chapter 3. Quick Installation Guide; Tcp/Ip Configuration - TP-Link TD-w8960n User Manual

300mbps wireless n adsl2+ modem router

Hide thumbs Also See for TD-w8960n:

Table of Contents

TD-W8960N

Chapter 3. Quick Installation Guide

This chapter will show you how to configure the basic functions of your TD-W8960N 300Mbps

Wireless N ADSL2+ Modem Router using Quick Setup Wizard within minutes.

The default IP address of the TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router is

192.168.1.1. And the default Subnet Mask is 255.255.255.0. These values can be changed as you

desire. In this guide, we use all the default values for description.

Connect the local PC to the LAN/WAN port of the Router. And then you can configure the IP

address for your PC in the following way.

Obtain an IP address automatically



Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC.

If you need instructions as to how to do this, please refer to

PC".

Then the built-in DHCP server will assign IP address for the PC.

Now, you can run the Ping command in the command prompt to verify the network connection.

Please click the Start menu on your desktop, select run tab, type cmd or command in the field

and press Enter. Type ping 192.168.1.1 on the next screen, and then press Enter.

If the result displayed is similar to the screen below, the connection between your PC and the

router has been established.

If the result displayed is similar to the screen shown below, it means that your PC has not

connected to the router.

300Mbps Wireless N ADSL2+ Modem Router User Guide

Figure 3-1

Figure 3-2

Appendix B: "Configuring the

Table of Contents