Table of Contents
Advertisement
INSTALLATION
MINIMUM FIREPLACE
DIMENSIONS
The minimum fireplace dimensions for the
Regency gas space heater are shown in the
following diagrams:
Premium Flush Front Framing
When installing the Premium Flush Front, the
walls surrounding the zero clearance kit must
be made of non-combustible material. See
Diagram below.
6
MINIMUM
CLEARANCES TO
COMBUSTIBLES
The minimum fireplace clearances for the
Regency gas space heater are shown in the
following diagrams:
From Unit:
Sides
A 250 mm
Ceiling
B 1220 mm
Mantel
C see Mantel
Clearances
From Surround (660 mm x 1016 mm):
Sides
D 96 mm
Ceiling
E 1066 mm
Max. Mantle Depth
G 305 mm
Hearth Height
H 0 mm
Hearth Depth
I
300 mm*
Hearth Width
J 1100 mm
Min. Alcove Width
K 1262 mm
Max. Alcove Depth
L 915 mm
* NOTE: No hearth required with screen. Floor
finishing material must not be any higher then
the base of the fireplace.
Mantel Clearances
Note: A non-combustible mantel may be
installed at a lower height if the fram-
ing is made of metal studs covered
with a non-combustible board.
GAS CONNECTION
GAS CONNECTION WARNING:
Only persons licensed to work
with gas piping may make the
necessary gas connections to this
appliance.
1) If the appliance is to be installed into an
existing chimney system or Zero Clearance
Box, thoroughly clean the masonry or factory
built fireplace.
2) The gas connection is 1/2" BSP.
3) Locate the center point where the flue will
pass through the chimney above the appli-
ance. Move the appliance into the exact
location where it is to be installed. Ensure
that the Insert is level.
CAUTION: If the glass is removed for servic-
ing, it must be replaced and closed prior to
operating the appliance.
Regency IG35 Gas Inbuilt Fireplace
Advertisement
Table of Contents
