Advertisement
Available languages
Available languages
The following instructions should be read by a qualified technician
to ensure that the appliance is installed, regulated and technically
serviced correctly in compliance with current regulations.
Important: The power supply to the appliance must be cut off
before any adjustments or maintenance work is done on it.
Installation of the cooker
The appliance can be installed next to furniture units which are
no taller than the top of the cooker hob. The wall in direct contact
with the back panel of the cooker must be made of non-flamma-
ble material. During operation the back panel of the cooker could
reach a temperature of 50°C above room temperature. For proper
installation of the cooker, the following precautions must be taken:
a) The appliance can be placed in a kitchen, dining room or
bedsit, but not in a bathroom.
b) All furniture around the appliance must be placed at least
200 mm from the top of the cooker, should the surface of the
appliance be higher than the worktop of this furniture. Cur-
tains should not be placed behind the cooker or less than
200 mm away from the sides of the appliance.
c) Any hoods must be installed according to the requirements
in the installation manual for the hoods themselves.
d) If the cooker is installed beneath a wall cabinet, the latter
must be situated at a minimum of 420 mm above the hob.
The minimum distance between the worktop and kitchen
units made of combustible material is 700 mm.
e) The wall in direct contact with the back panel of the cooker
must be made of non-flammable materials.
Min.
Levelling Your Appliance (only on certain models)
4 support feet which are adjusted using screws are located in
the lower part of the cooker. These level off the oven when
necessary. It is essential that the cooker be standing level.
Mounting the legs (only on certain models)
Press-fit legs are supplied which fit under the base of your cooker.
Installation Instructions
HOOD
600
mm.
Cooker height adjustment
The cooker is factory-set to a 900 mm height. It can be
reduced to an 850 mm height by dismounting the
removable part of the base. Remove the warming drawer.
Using a screwdriver, unscrew the 6 "B" screws. Remove
the adjustable feet "A" too (see fig. A). To level the cooker,
screw in adjustable feet "A" on the cooker bottom (see fig.
B).
B
Fig. A
Electrical Connection
Those ovens equipped with a three-pole power supply
cable are designed to operate with an alternating current
with the voltage and frequency indicated on the data plate
(located on the appliance) and in the instruction manual.
The wire for earthing the appliance is yellow-green in col-
our.
Fitting on a Power Supply Cable
Opening the terminal board:
•
Using a screwdriver, prise on the side tabs of the terminal
board cover;
•
Pull open the cover of the terminal board.
To install the cable, proceed as follows:
•
unscrew the wire clamp screw and the contact screws
Note: the jumpers are factory-set for a single-phase 230V
connection (Fig. A).
•
to make the electrical connections illustrated in fig. C and fig.
D, use the two jumpers housed in the box (fig. B - reference
"P")
4
A
A
Fig. B
Advertisement
