Genie S-40 Maintenance Manual page 109

April 2016
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Open the ground controls side turntable side
cover.
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 At the ground controls, turn the
bypass/recovery key switch to the run
position.
4 Turn the main key switch to ground control,
start the engine and then turn the key switch
to platform control.
5 Check any machine function from the ground
controls.
Result: The machine functions should not
operate.
6 Turn the main key switch to ground control.
7 Check any machine function from the platform
controls.
Result: The machine functions should not
operate.
8 Turn the main key switch to the off position.
Result: The engine should stop and no
functions should operate.
9 Turn the main key switch to ground control
and start the engine.
Part No. 1268489
Annual Maintenance Procedures
10 Remove the key from the main key switch.
Insert the key into the bypass/recovery key
switch and turn it to the bypass position.
Note: The main key switch must remain in the
ground control position.
11 Raise the primary boom 3 ft / 1 m.
Result: The primary boom should raise.
12 Remove the key from the bypass/recovery
key switch and insert the key into the main
key switch.
13 Turn the main key switch to the off position.
14 Remove the key from the main key switch and
insert the key into the bypass/recovery key
switch.
15 Turn and hold the bypass/recovery key switch
to the recovery position. The switch must be
held in the recovery position.
Result: The primary boom lowers to the
stowed position.
16 Turn the bypass/recovery key switch to the
run position.
17 Remove the key from the bypass/recovery
key switch and insert the key into the main
key switch.
18 Close the turntable side cover.
S Booms • Z Booms
Maintenance Manual
97