[Fax Header Settings] ([File Re-Tx]) ([Fax Tx]); [Line Setting] ([File Re-Tx]) ([Fax Tx]) - Konica Minolta bizhub c654 User Manual

15

[Fax Header Settings] ([File Re-TX]) ([Fax TX])

To display: [Box] - [System] - [File Re-TX] - Select the file - [Fax TX] - [Application] - [Fax Header Settings]
Normally, the default sender name is added. However, you can use different sender names depending as
necessary.
If you want to use a sender name that is different from the default name, select a new sender name you want
to use, then tap [OK].

[Line Setting] ([File Re-TX]) ([Fax TX])

To display: [Box] - [System] - [File Re-TX] - Select the file - [Fax TX] - [Application] - [Line Setting]
Specify how to send a fax based on the line conditions.
Settings
[TX Method]
[Check Dest. and Send]
[Select Line]
15-184
Description
Change the communication mode based on the line conditions.
• [Overseas TX]: Select this option to send a fax to areas where commu-
nication conditions are poor. Faxes are sent at a lower speed.
• [ECM]: Generally, faxes are sent while checking that the fax data is free
of errors by using ECM (Error Correction Mode). To reduce the time re-
quired to send a fax, cancel the setting.
• [V.34]: Generally, faxes are sent in the Super G3 mode. If it is not pos-
sible to send faxes in the Super G3 mode, cancel the setting.
Select this option to use the Check Dest. And Send function.
The fax number specified for fax is checked against the remote fax number
(CSI) and the fax is sent only when they match.
If two lines are used, select the line used to send faxes.
If [No Selection] is selected, either line, whichever is not busy, is used for
transmission.
bizhub C754/C654