Table of Contents
Advertisement
Fuser Replacement
The fuser is located inside the MFP just behind the four image drum units.
If the MFP has recently been in use, some fuser components will be
very hot. Handle the fuser with extreme care, holding it only by its
handle, which will only be mildly warm to the touch. A warning
label clearly indicates the area.
1.
Switch off the MFP and allow the fuser to cool for about 10 minutes before opening
the cover.
2.
Pull the lever (a) firmly to release the lock and then gently raise the scanner (b).
3.
Press the cover release (a) and open the top cover (b) fully.
WARNING!
a
Maintenance > 128
Advertisement
Table of Contents
