Reset +Wrst; Set Standard Tone +Wsst - Multitech MMCModem GPRS (MTMMC-G) Reference Manual

Reset +WRST

Description:
This command resets the modem after the time specified by the <delay> parameter.
Values: <val1>
<Delay> specify the time for reset
<RemainTime> time before next reset
Syntax: Command syntax: AT+WRST =<Mode>,<Delay>
Response syntax: +WRST: <Mode>,<Delay>,<RemainTime>
Command
AT+WRST=?
AT+WRST=0
Note: Disable timer
AT+WRST=1,"001:03"
Note: Enable timer and put delay at 1 hour 3
minutes
AT+WRST?

Set Standard Tone +WSST

Description:
This command sets and gets the sound level of the Standard Tones.
Values: <sound level> Range [0; 15]
<ring tone level> Range [0; 15]
Syntax: Command syntax:
Command
AT+WSST=0
Note: Set volume to Maximum
AT+WSST=15
Note: Set volume to Minimum
AT+WSST=,5
Note: Set ring tone level to 5
AT+WSST?
Note: get current standard tones
sound level
AT+WSST=?
Note: supported parameters
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I)
0
timer reset is disabled
1
timer reset is enabled
Range "000:00"- "168:59" (format hhh:mm)
Range "000:01"- "168:59" (format hhh:mm)
0
Maximum volume (default)
15 Minimum volume
0
Maximum volume (default)
15 Minimum volume
AT+WSST=[<sound level>][,<ring tone level>]
Possible responses
OK
OK
OK
+WRST: 1,"001:03","001:01"
OK
Note: Timer activated to reset after 1 hour and 3
minutes. At this point, 1 hour and 1 minute remain
before next reset.
Possible responses
OK
OK
OK
+WSST: 15,5
OK
Note: current standard tones level is 15
(minimum), and ring tone level is 5.
+WSST: (0-15),(0-15)
OK
Chapter 13 – Specific AT Commands
135