Dte-Dce Local Flow Control +Ifc; Set Dcd Signal &C - Multitech MMCModem GPRS (MTMMC-G) Reference Manual

DTE-DCE Local Flow Control +IFC

Description:
This command is controls the operation of local flow control between the DTE and DCE.
Values: < DCE_by_DTE >
< DTE_by_DCE >
Syntax: Command syntax: AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>
Command
AT+IFC?
AT+IFC=?
AT+IFC=0,0
Set DCD Signal &C
Description:
This commands controls the Data Carrier Detect (DCD)
Values: <n>
Syntax: Command syntax: AT&C <n>
Command
AT&C0
Note: DCD always on
AT&C1
Note: DCD matches state of the remote
modem's data carrier
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I)
0 none
1 Xon/Xoff local circuit 103
2 RTS
3 Xon/Xoff global on circuit 103
Important Note:
When this parameter is set to 2 (DTE invokes flow control through RTS) DCE
behaviour is as follows:
•
If the DCE has never detected RTS in the high (or ON) condition since startup then it ignores
RTS as it assumes that this signal is not connected.
•
As soon as the DCE detects RTS high the signal acts on it. Therefore subsequent RTS
transition to OFF will prevent the DCE from sending any further data in both online and
offline modes.
•
This behavior allows the user to use the default settings (hardware flow control) and leave
RTS disconnected. In the case where RTS is connected and is high at least once, it acts on
the DCE.
0 none
1 Xon/Xoff circuit 104
2 CTS
Note: When this parameter is set to 0 (none), then CTS is kept high all the time.
Possible responses
+IFC: 2,2
OK
Note: Current values
+IFC: (0,2),(0,2)
OK
Note: Possible values
OK
Note: New values
0
DCD always on
1
DCD matches the state of the remote modem's data carrier
Chapter 12 – V.24 and V.25 Commands
(supported)
(not supported)
(supported)
(not supported)
(supported)
(not supported)
(supported)
signal.
Possible responses
OK
Note: Command valid
OK
Note: Command valid
101