GRAUPNER POLARON EX-1400 Operating Instructions Manual page 34

With another tap on the DEC button (down arrow) at the bottom of the display you can change
from the second display of "BALANCE" menus to the third:
In this third display of "BALANCE" menu are shown graphically, the actual cell
BA LAN CE 01:37:37
PM
voltages of the battery packs connected to the CH1 and CH2 balancer.
4.124v 4.108v 0.016v
8N
1N 2N 3N 4N 5N 6N 7N
4.1 16Vc 0.040Vr 0.0mΩ
AUTO 1N 4.124V
CH1 CH2
1 Numerical display of the lowest and highest cell voltage and the voltage
BA LAN CE 01:37:37
PM
1
4.124v 4.108v 0.016v
2 Graphical representation of the cell voltages of the connected battery pack
2
3 Vc = Voltage center (the center line voltage value actually assigned)
3
4 Vr = Voltage range (vertical range of the voltage display)
5 It is possible to switch between "AUTO" and "MANUAL" just by tapping.
8N
1N 2N 3N 4N 5N 6N 7N
3 4
4.1 16Vc 0.010Vr 0.0mΩ
6 Actual cell voltage of "cell 1" can be scrolled through the values of the indi-
AUTO 5 1N 4.124V 6
CH1 CH2
After pressing the ENTER button at the bottom right in one of the displays of the "BALANCE"
menu the Graupner polaron EX-1400 charger starts to check respective cell charge of the lithium
battery connected to the balancer output and then to balance:
The labeling of the display changes to "Balance" and the height of the bars
Balance 01:37:54
PM
begins to align gradually.
4.124v 4.108v 0.016v
1N 2N 3N 4N 5N 6N 7N 8N
4.1 16Vc 0.040Vr 0.0mΩ
AUTO 1N 4.124V
CH1 CH2
34
difference
In"manual" mode are "3" and "4" also manually settable.
vidual cells by tapping.