GRAUPNER POLARON EX-1400 Operating Instructions Manual page 26

After the expiration of the aforementioned 5 seconds within which you should
DISCHG 01:24:06
PM
have at least made the choice of a particular discharge mode as well as the
00 NiCd Auto Mode
input of a delayed start, it starts an automatic battery test.
Charge Mode 0
NONE If no battery is connected, or an improper battery is detected, after completion
Discharge Mode of the battery test it will be shown an appropriate error message, see „Alert
AUTO
messages" on page 48.
Battery Check!!
Start Verz. Zeit
Checking Battery...
0 0:0 0 : 0 0
CH1 CH2
NiCd and NiMH batteries charge process starts as described below by way of
DISCHG 01:24:12
PM
example for a lithium battery after about 5 seconds. For lithium batteries and
13 LiPo 03s 2200
PB after few seconds the battery test, it is carried out a review of the number
Charge Mode 5
of cells connected batteries.
NONE
Discharge Mode
NORMAL
Connected Check
Start Verz. Zeit
[ 3 ] cells are now con-
balancer to the charger, the cell count is determined by the balancer and the
nected at the balancing
00 :00 :0 0
outcome of the review appears as shown on the left example.
port.
CH1 CH2
DISCHG 01:24:12
PM
13 LiPo 03s 2200
Charge Mode 5
the cell count is based on the settings manually input and the outcome of the
NONE
review appears as shown on the left example.
Discharge Mode
NORMAL If the displayed number of cells matches the actual number of cells of the con-
nected battery, wait until after about 5 seconds - as described below - charge
Select Cells
Start Verz. Zeit
will start automatically.
Select[ 3 ] cells to be
charged or discharged
00 :00 :0 0
CH1 CH2
DISCHG 01:24:12
PM
13 LiPo 03s 2200
Charge Mode 5
cells with one of these buttons accordingly. As an indication of the manual
NONE
intervention the color of the header information when prompted changes be-
Discharge Mode
NORMAL tween red and blue.
Verbindungs Check
** Check Cells **
Start Verz. Zeit
Select [ 4 ] cells to be
charged or discharged
00 :00 :0 0
plode and / or burn!
Press the ENTER button on the bottom right to start the discharge process.
CH1 CH2
26
For lithium batteries and PB after few seconds the battery test, it is
carried out a review of the number of cells connected batteries. Is the
battery to charge connected not only with the charger, but also with a
For lithium batteries and PB after few seconds the battery test, it is
carried out a review of the number of cells connected batteries.
Is the battery to charge connected without a balancer to the charger,
If the displayed number of cells, however, is NOT matching the actual
number of cells of the battery connected, then stop the automatic
timing by pressing the INC or DEC key and then adjust the number of
ATTENTION!
!
As a result of incorrectly set number of cells or even a value too
far from cell voltages due to the balancer port, battery can ex-