GRAUPNER POLARON EX-1400 Operating Instructions Manual page 29

C Auto Discharge current acquired from the menu "DISCHARGE".
The discharge can therefore be adjusted as necessary
only in the menu "DISCHARGE".
Once the settings are matching with your wishes, go to ...
Start of cycle
... Tap the ENTER button on the bottom right of the display brings on the sec-
CYCLE 09:02:23
C-D PM
ond display page of the „CYCLE" menu.
00 NiCd Auto Mode
In parallel, the battery charger balancer checks the active channel CH1 or CH2
Charge Mode
AUTO charge and compares the number of cells of the connected battery with the
Discharge Mode default settings, then, if necessary, appropriate messages are shown on the
AUTO
display.
Balancer port
is not connected...
0 0:00 :00
CH1 CH2
Then you have about five seconds to change the material transferred from the
CYCLE 09:02:32
C-D PM
menus "CHARGE" or "DISCHARGE" and charge and discharge mode and, if
00 NiCd Auto Mode
necessary, set a start delay.
Charge Mode 5
AUTO
Discharge Mode
AUTO
Start Delay Time
0 0:0 0: 00
CH1 CH2
Available combinations of charge and discharge modes
Battery type
NiCd and NiMH batteries
LiFe, LiIo, LiPo batteries
Pb batteries
Charge mode Battery type
AUTO NiCd and NiMH batteries
NORMAL
LINEAR
CC/CV LiFe, LiIo, LiPo batteries
CV-LINK
CC/CV Pb batteries
INNOVATION & TECHNOLOGIE
Discharge mode
AUTO
NORMAL
LINEAR
NORMAL
LINEAR
NORMAL
LINEAR
29