GRAUPNER POLARON EX-1400 Operating Instructions Manual page 22

NiCd and NiMH batteries charging process starts as described below by way
CH AR GE 06:12:34
PM
of example for a lithium battery after about 5 seconds.
13 LiPo 03s 2200
For lithium batteries and PB after few seconds the battery test, it is carried out
Charge Mode 5
CC/CV a review of the number of cells of the connected battery.
Discharge Mode
NONE
Connect Check
Start Verz. Zeit
[ 3 ] cells are now con-
ple.
nected at the
00 :00 :0 0
balancing port.
CH1 CH2
CH AR GE 06:12:34
PM
13 LiPo 03s 2200
Charge Mode 5
left image.
CC/CV
If the displayed number of cells matches the actual number of cells of the con-
Discharge Mode
NONE nected battery, wait until after about 5 seconds - as described below - charge
will start automatically.
Select Cells
Start Verz. Zeit
Select[ 3 ] cells to be
charged or discharged
00 :00 :0 0
CH1 CH2
CH AR GE 06:12:34
PM
13 LiPo 03s 2200
Charge Mode 5
cells with one of these buttons accordingly. As an indication of the manual
CC/CV
intervention the color of the header information when prompted changes be-
Discharge Mode
NONE tween red and blue.
Zellenzahl auswählen
** Check Cells **
Start Verz. Zeit
Select [ 4 ] cells to be
charged or discharged
00 :00 :0 0
can explode and / or burn!
Press the ENTER button on the bottom right to start charging.
CH1 CH2
After the lapse of the aforementioned 5 seconds or if necessary, after a manu-
06:14:44
PM
al start, charge process is begun. Otherwise, an error message is shown.
13 LiPo 03s 2200
Note:
CC/CV 00:01:56
Tap the image to go directly to the „data display", see page 35.
67
0.0°C mAh
11.678 2.20
V A
11.97Vin 33.3mΩ
11,789 0,067
Vc Vr
CH1 STOP STOP CH2
22
Is the battery to charge connected not only with the charger, but also
with a balancer to the charger, the cell count is determined by the
balancer and the outcome of the review, as shown on the left exam-
If the lithium or PB battery to charge is connected only with the charg-
er cable to the charger, the detected cell count is based on the total
current battery voltage and the outcome of the review is shown on the
Is the displayed number of cells, however, NOT matching the actual
number of cells of the connected battery, then stop the automatic
timing by pressing the INC or DEC button and adjust the number of
ATTENTION!
!
As a result of incorrectly set number of cells or even a value too
far from cells voltage connected to the balancer port, battery