Set Up Instructions - Stamina 85-2221A Owner's Manual

SET UP INSTRUCTIONS

TM
Place the Wirk Ride Workstation in the area where it will be used. It is recommended that the Wirk
Ride Workstation be placed on an equipment mat. The Wirk
inches long x 21.7 inches wide x 45.7 inches tall. (These dimensions may vary up to one inch.) An area
4 feet wide x 6 feet long is required for safe operation of the Wirk
adequate space is available for access to and passage around the Wirk
LEVELING: Adjust the LEVELING CAPS(31) on the REAR STABILIZER(10) so that the Wirk
Workstation sits on the floor without rocking.
MOVING: The Wirk
Hold the HANDRAIL(8) and tilt back on WHEELS(32) to move the Wirk
Workstation.
FUNCTION INSPECTION:
Visually inspect the Wirk
illustration. Check the function of the Wirk
complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(57) and
verify that it functions properly and the resistance changes.
CAUTION: Locate and read the CAUTION LABEL(103) on the WirkTM Ride Workstation. Make sure
that all users read the CAUTION LABEL(103) before using the product.
TM Ride Workstation has a pair of WHEELS(32) on the REAR STABILIZER(10).
TM
Ride Workstation to verify that assembly is as shown in the above
TM Ride Workstation by turning the crank slowly through one
11
TM
Ride Workstation is approximately 45
TM
Ride Workstation. Make sure that
TM
Ride Workstation.
Equipment Mat
(not included)
TM
TM
Ride
TM
Ride