Stamina 85-2221A Owner's Manual page 10

ASSEMBLY INSTRUCTIONS
STEP 11
NOTE: The RIGHT PEDAL(52) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(52) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(43) has L stamped on the end
of the pedal shaft. The LEFT PEDAL(43) has left hand threads and is tightened by turning counterclockwise.
Thread the RIGHT PEDAL(52) to the RIGHT CRANK(51) as shown. Tighten the pedal securely. Refer to
the detail view below. The shoulder of the PEDALS(43, 52) should be in contact with the CRANKS(44, 51)
when securely tightened. Select the RIGHT PEDAL STRAP(97) which has R marked on the bottom side of
the strap. Snap the three hole end to the inside edge of the RIGHT PEDAL(52). Snap the other end to the
outside edge of the RIGHT PEDAL(52) with the R mark on the bottom of the RIGHT PEDAL STRAP(97).
Select adjustment holes which allow your foot to be easily removed from the pedals.
Repeat on the left side in order to attach the LEFT PEDAL(43) to the LEFT CRANK(44) and snap the LEFT
PEDAL STRAP(96) to the LEFT PEDAL(43).
STEP 12
Refer to the illustration. Pry the METER(19) from the DESKTOP(21). Install two AAA batteries into the
METER(19), the batteries are not included. See page 12 for detailed battery installation instructions. Press the
METER(19) back to the DESKTOP(21). Plug the CONNECTION WIRE(59) into the wire of the METER(19).
Shoulder
Shoulder
Shoulder
10