Printing Precautions; Cut Modes (Auto Cutter) - Casio KL-G2TC User Manual

Exiting Text Creation and Tape Printing
1.
When the screen shown above is on the display, select 結束 (Exit) and
then press 執行 twice.
This returns to the screen shown below.

Printing Precautions

Important!
Never turn off printer power while printing is in progress.
Never open the tape compartment cover while printing is in progress.
(page 12)
Do not touch the tape coming out of the printer until it is automatically cut or
until printing is complete.
Avoid allowing tape cuttings to pile up around the printer tape outlet.
Tape cuttings around the tape outlet creates the risk of tap jamming and
malfunction.

Cut Modes (Auto Cutter)

When printing multiple labels during a single print operation, you can
confi gure printer settings that control whether or not there should be an
automatic cut between each of them. Depending on the type of tape you are
printing, use of the cutter can cause cutter wear and malfunction.
The tape types in the table below are special tape. Make sure you use 特殊
(Special Tape) or 不裁切 (Uncut) whenever printing on special tape.
Iron-on transfer tape
Magnetic tape
Refl ective tape
Iron-on fabric tape
Heat shrink tube
■ Cutting Types
The printer can perform two types of cutting.
Half Cut
Half Cut cuts only the sticker part of
the tape without cutting the backing
paper. This means you can peel labels
from the backing paper as you need
them.
Full Cut
Full Cut cuts both the backing paper
and the sticker parts.
特殊 (Special Tape)
不裁切 (Uncut)
Full cut
Half cut Half cut
21 EN