Connecting The Printer To A Computer; Initializing Memory - Casio KL-G2TC User Manual

Connecting the Printer to a Computer

Important!
Be sure to install the printer software on your computer before connecting
the printer to it.
1.
Start up Windows and then connect a USB
cable* to a USB port on the computer.
* Use a commercially available cable
(A-microB type) that complies with USB
standards.
2.
Connect the USB cable to the printer USB port.
Important!
When connecting for the fi rst time, remove the sticker from the printer's USB
port.
3.
On the printer, press ON.
4.
On the printer, press PC連接 .
This will display a USB driver install wizard on your computer. A
USB driver is required for proper data communication between your
computer and printer. Follow the instructions that appear on your
computer screen to install.
If your computer is running
Windows XP Service Pack3 (SP3),
the message shown nearby will
appear sometime during
installation. Select No, not this
time and then click Next to
proceed with the installation.
14 EN
The message 通訊準備完畢 (Ready to transfer data) will appear on the
printer display after USB driver installation is complete.
Important!
To print computer data with the printer, fi rst press PC連接 on the printer to
display the message 通訊準備完畢 (Ready to transfer data) on the printer
display.
For information about how to use the PC Link software, refer to the Label
Printing Software FA-3000 User's Guide.

Initializing Memory

Initialize printer memory before using it for the fi rst time.
Important!
Note that initializing memory will delete all currently stored data. You should
only initialize memory before using the printer for the fi rst time.
1.
Check to make sure that the printer is turned off.
If power is on, press OFF.
2.
While holding down and 變換 / 空白 , press ON.
Keep all of the keys depressed until the message 初始化記憶體 ? 執行 /
取消 (Initialize? Set/Esc) appears on the printer display.
3.
Press 執行 .
4.
Confi gure current date and time settings.
After settings are the way you want, press
執行 .
You can change the date and time settings
later, if you want (page 54).