Feeding Tape - Casio KL-G2TC User Manual

4.
Press the arrow key.
5.
Specify a cut mode.
Cut modes are explained in the table below.
Select this mode: To do this:
Print without cutting the backing paper
通常 (Normal)
between labels.
切斷 (Cut) Cut between labels.
特殊 (Special Tape) Print on iron-on transfer tape.
Print on refl ective tape, magnetic tape or iron-
不裁切 (Uncut)
on fabric tape.
Here, we will specify 通常 (Normal).
6.
Press 執行 .
This starts printing.
The backlight will be unlit while printing is in progress.
To interrupt printing part way through, press 取消 .
Affi xing a Label to a Surface
1.
If required, use scissors or some other implement to trim the label to the
desired size or shape.
2.
Peel off the backing of the label and affi x the
label to the desired surface.
Peeling off the backing of a half cut label
Carefully twist at the half cut point and then
peel the backing from the label.
Peeling off the backing of a full cut label
Bending a corner of the label makes the backing easier to peel off.
Removing a label from a surface where it was affi xed may cause
adhesive residue to remain on the surface.
20 EN
Important!
Do not try to affi x a label to the objects or in the locations described below.
On a surface exposed to direct sunlight or rain
On the body of a person or animal
On a utility pole, on a fence or structure not owned by you, etc.
On a container used for heating in a microwave oven
Incompatible Surfaces
Rough or grainy surfaces
Wet, oily, dusty, or otherwise soiled surfaces
Special plastic (silicon, polypropylene, etc.) surfaces

Feeding Tape

You can perform a tape feed operation either before or after printing.
1.
Press 功能 and then .
This feeds the tape approximately 21mm.
Finalizing a Print Operation when 不留 (None) is
Selected for the Margin Setting
When 不留 (None) is specifi ed for the margin setting (page 30), the printer
does not cut the tape automatically at the end of a print operation. In this
case, perform the operation below to cut the tape.
1.
Press 功能 and then .
This cuts the tape.