Media Size Mismatch In Width - Lexmark C935 Service Manual

Step
4 Perform a POR.
Does the error continue when the power is turned off/
on?
5 Perform a POR.
Does the error continue when the power is turned off/
on?

Media size mismatch in width

Step
1 Check the media.
Is media properly loaded in the tray?
2 Check the media.
Is the rear media tray guide, and media tray end guide of tray
1 or tray 2 set correctly?
3
Check the switch (media size) for proper installation.
Pull out the media tray to visually check it.
Is the switch (media size) for media tray 1 and media tray 2
installed correctly?
4 Check the switch (media size) connection for tray 1 and/or
tray 2.
Is the switch (media size) properly connected for tray 1 and/or
tray 2?
5 Perform a print test.
Does the error continue when the power is turned off/on?
Check
Check
Yes
Replace the duplex Problem solved.
controller card
assembly.
Go to "Duplex
controller card
assembly removal"
on page 4-14.
Go to step 5.
Replace the lower Problem solved.
printer engine card
assembly.
Go to "Lower
printer engine card
assembly removal"
on page 4-93.
Yes
Go to step 2. Load media
properly.
Go to step 3. Set the guides
properly.
Go to step 4. Install the switch
(media size) for
each media tray
correctly.
Replace the Replace the
required switch connection.
(media size).
Go to "Switch
(media size)
removal" on
page 4-121.
Replace the Problem solved.
upper printer
engine card
assembly.
Go to "Upper
printer engine
card assembly
removal" on
page 4-90.
Diagnostic information
5057-XXX
Previous
No
Next
Go Back
No
2-129