Sensor (Tray 2 Feed-Out) Late Jam - Lexmark C935 Service Manual

Step
9 Perform a print test.
Does the error continue?

242.00 Sensor (tray 2 feed-out) late jam

Step
1 Check the media condition.
Is the media in the tray crumpled or damaged?
2 Check the media size setup.
Does the media size, in use, match the size set for tray 2?
3 Check the feed roll, separation roll, and pick roll for media
tray 2.
Are the above components free of excess wear and
contamination?
4 Check the media position.
Does the media touch the sensor (tray 2 feed-out)?
5 Check the sensor (tray 2 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Select INPUT TRAY TESTS.
3. Select Sensor test.
4. Select Tray 2.
5. Select Feed-out.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
6 Check the sensor (tray 2 feed-out) for proper connection.
Is the above component properly connected?
Check
Check
Yes
Replace the lower Problem solved.
printer engine card
assembly.
Go to "Lower
printer engine
card assembly
removal" on
page 4-93.
Yes
Replace the Go to step 2.
damaged media
with new.
Go to step 3. Replace the
media, or change
the media size
setup.
Go to step 4. Clean or replace
the feed roll,
separating roll, or
pick roll.
Go to "Feed roll
removal" on
page 4-115,
"Separation roll
removal" on
page 4-117, and
"Pick roll
removal" on
page 4-116.
Remove the Go to step 5
media.
Go to step 7. Go to step 6.
Replace the Replace the
sensor (tray 2 connection.
feed-out).
Diagnostic information
5057-XXX
Previous
No
Next
Go Back
No
2-39