Toro Greensmaster TriFlex 3300 Service Manual page 49

2. Close fuel shut--off valve on fuel tank.
3. Remove air cleaner and air intake hose from ma-
chine (see Air Cleaner Removal in this section).
4. Remove radiator from machine (see Radiator Re-
moval in this section).
5. Remove exhaust system from machine (see Ex-
haust System Removal in this section).
6. Disconnect fuel supply hose from the injector pump
and fuel return hose from the #3 injector. Drain any fuel
trapped in the hoses into a suitable container. Remove
hoses from grommets in engine support on front of en-
gine. Plug hoses and position them away from engine
assembly.
7. Loosen screw that secures the throttle cable to swiv-
el on injector pump speed control lever. Disconnect
cable from swivel and cable bracket (Fig. 10). Position
cable away from engine.
8. Disconnect wire harness connectors from engine
components:
NOTE: Before disconnecting wire harness connectors,
label all electrical leads for assembly purposes.
A. Negative battery cable and wire harness ground
from lower engine mount fastener (Fig. 11).
B. Fuel stop solenoid (Fig. 12).
C. Glow plug bus (Fig. 12).
D. Temperature sender (Fig. 12).
E. Alternator connector and stud (Fig. 13).
F. Starter motor solenoid and fusible link harness
(Fig. 13).
G. Oil pressure switch (near oil filter) (Fig. 13).
CAUTION
Support the hydraulic pump assembly when re-
moving its supporting fasteners to prevent it
from falling and causing damage or personal in-
jury.
9. Support hydraulic pump assembly to prevent it from
moving during engine removal.
10.Remove two (2) cap screws and flat washers that se-
cure hydraulic pump assembly to bell housing on en-
gine.
Greensmaster 3400
1
1. Throttle cable
2. Speed control lever
1
1. Engine mount
2. Negative cable
1
1. Fuel return hose
2. Throttle cable swivel
3. Fuel stop solenoid
Page 4 - - 15
3
2
Figure 10
3. Cable jam nut
4. Throttle cable swivel
3
Figure 11
3. Wire harness ground
5
4
2
Figure 12
4. Glow plug bus
5. Temperature sender
Diesel Engine
4
2
3