Toro Greensmaster TriFlex 3300 Service Manual page 253

Removal (Fig. 18)
1. Park machine on a level surface, engage the parking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Remove grass basket from suspension assembly.
3. Remove cutting unit from suspension assembly (see
Traction Unit Operator's Manual).
4. If front suspension assembly is to be removed, re-
move front wheel (see Wheel Removal in this section).
This will allow easier access to flange head screws that
secure suspension assembly to frame.
5. Remove hydraulic hose bracket from suspension as-
sembly (Fig. 19 or 20).
6. Position and support reel motor and attached hy-
draulic hoses away from suspension assembly.
CAUTION
Support suspension assembly when removing it
to prevent it from falling and causing personal in-
jury. Suspension assembly weighs approximate-
ly 65 pounds (30 kg).
7. Support suspension assembly to prevent it from
shifting or falling.
8. Remove three (3) flange head screws (item 2) that
secure suspension assembly to machine frame. Re-
move suspension assembly from machine.
Installation (Fig. 18)
1. Make sure that all suspension components are cor-
rectly assembled.
2. Position suspension assembly to frame. Align
mounting holes and secure suspension with three (3)
flange head screws (item 2). Torques screws from 55 to
60 ft- -lb (75 to 81 N- -m).
3. Position reel motor and attached hydraulic hoses to
suspension assembly. Insert reel motor shaft into stor-
age location on front of suspension assembly.
4. Secure hydraulic hose bracket to suspension as-
sembly (Fig. 19 or 20). Torque two (2) socket head
screws from 85 to 115 in- -lb (9.6 to 12.9 N- -m).
5. Install cutting unit to suspension assembly (see
Traction Unit Operator's Manual).
6. Install grass basket to suspension assembly.
Greensmaster 3300/3400
7
1
2
3
3
4
5
1. Cap screw (4 used)
2. Strap (2 used)
3. Tube clamp (4 used)
4. Hose bracket
5. Flange nut (4 used)
11
10
9
3
8
4
5
6
1. Screw (2 used)
2. Tube clamp (2 used)
3. Cap screw
4. R- -clamp (2 used)
5. R- -clamp
6. Hose bracket
Page 7 - - 23
FRONT CUTTING UNIT
8
85 to 115 in- -lb
(9.6 to 12.9 N- -m)
9
6
Figure 19
6. Socket screw (2 used)
7. Case drain hose
8. Pressure hose
9. Return hose
1
CENTER CUTTING UNIT
2
85 to 115 in- -lb
(9.6 to 12.9 N- -m)
7
Figure 20
7. Socket screw (2 used)
8. Cap screw
9. Pressure hose
10. Case drain hose
11. Return hose
Chassis