Toro Greensmaster TriFlex 3300 Service Manual page 315

Disassembly (Fig. 30)
1. Remove flange nut (item 2) that secures lift arm to
HOC groomer arm. Remove lock nut (item 16) and
spring washer (item 17) that secure lift arm to side plate.
Loosen lock screw (item 6) completely.
2. Remove flange nut (item 2) that secures lift arm as-
sembly to HOC groomer arm. Remove lock nut (item 16)
and spring washer (item 17) that secure lift arm as-
sembly to side plate. Loosen lock screw (item 6) com-
pletely.
3. Remove lift arm assembly from cutting unit.
4. Disassemble lift arm using Figure 30 as a guide.
NOTE: Right and left side HOC groomer arms (item 1)
and lift arm assemblies (item 8) are different; other com-
ponents shown in Figure 30 are the same on both sides
of cutting unit.
NOTE: Grooved pin (item 3) is used to retain lock screw
(item 6) to lift arm assembly.
Greensmaster 3300/3400
Assembly (Fig. 30)
1. Assemble lift arm using Figure 30 as a guide.
2. Apply antiseize lubricant to threads of groomer lift
rod (item 5) and lift arm assembly stud (item 8).
3. Install lift arm assembly onto cutting unit. Secure with
flange nut (item 2) and lock nut (item 16) with spring
washer (item 17).
4. Secure groomer in raised or lowered position with
lock screw (item 6).
5. Check and adjust grooming reel height and mower
height--of--cut settings.
Page 9 - - 25 Groomer