Toro Greensmaster TriFlex 3300 Service Manual page 133

7. If hydraulic fittings are to be removed from reel mo-
tor, mark fitting orientation to allow correct assembly.
Remove hydraulic fittings and O--rings from motor. Dis-
card removed O--rings.
8. Inspect threads and sealing surfaces of fittings and
motor ports. Replace components if damage is found.
Installation (Fig. 55)
1. If fittings were removed from reel motor, lubricate
and place new O--rings onto fittings. Install fittings into
reel motor openings making sure that fitting orientation
is as noted during removal. Tighten fittings (see Hydrau-
lic Fitting Installation in the General Information section
of this chapter).
2. Position motor mount to reel motor flange and se-
cure with two (2) retaining rings.
3. Install reel motor to the cutting unit:
A. Coat splines of reel motor shaft with clean
grease.
B. Align reel motor shaft splines with splines in cut-
ting reel. Slide reel motor into cutting unit side plate
(Fig. 57).
C. Pull motor clamp toward the motor until clamp ful-
ly engages slots on both sides of the motor mount
(Fig. 58). There should be an audible click as clamp
engages mount.
4. Remove caps and plugs from disconnected hydrau-
lic hoses and motor fittings.
5. Using labels placed during reel motor removal, lubri-
cate new O--rings and connect hydraulic hoses to reel
motor. Tighten hose connections (see Hydraulic Hose
and Tube Installation in the General Information section
of this chapter).
6. Check oil level in hydraulic reservoir and add correct
oil if necessary.
7. Follow Hydraulic System Start--up procedures (see
Hydraulic System Start--up in this section).
Greensmaster 3300/3400
1
1. Reel motor
2. Motor clamp
1
1. Reel motor
2. Motor clamp
1
1. Reel motor
2. Motor clamp
Page 5 - - 81
2
3
Figure 56
3. Cutting unit sideplate
2
Figure 57
3. Cutting unit sideplate
2
Figure 58
3. Cutting unit sideplate
Hydraulic System
3
3