Clearing Fault Codes
After fault codes have been retrieved, clearing of those
faults can be completed using the following switch se-
quence:
1. Place machine switches in fault retrieval (see
above). The diagnostic light should be displaying the
fault codes.
Electrical System
2. Operator seat should remain UNOCCUPIED.
3. Move backlap valve on mow control manifold to the
BACKLAP position.
4. Move joystick to the RAISE position.
5. Monitor the diagnostic light for continuous flashing
indicating that all faults have been cleared from the con-
troller memory.
Page 6 - - 10
Greensmaster 3300/3400