Water Purge Setting - Scotsman C0530SR-1 Technical Manual

Water purge setting

The water purge is factory set to the Automatic setting. The setting can be changed to one of 5
manual settings or placed on automatic. The purge setting shows in the Code Display.
purge 1 -
setting Minimum
RO water
or
Water
equivalent,
Type
TDS less
than 35
To set:
Switch the machine OFF by holding the Off button in until a number or the letter A shows on
the display.
Press and release the On button repeatedly until the number on the display corresponds to the
desired setting.
Press and release the Off switch again to return to the normal control state.
2 - 3 -
Moderate Standard
Low TDS Setting
non - RO for typical
water water
September 2006 Page 8
4 - 5 -
Heavy Maximum
Very high
High
TDS water,
TDS
greater than
water
256
A - Automatic
Any with
conductivity
not less than
10
microSiemens/
cm