C1448, C1848 D
Air and Water Cooled User Manual
Water flush setting
The water flush is factory set to the automatic
position, suitable for most water conditions. The
setting can be changed to one of 5 manual settings or
left on automatic.
Flush setting
1 - Minimum
Water Type
RO water or
equivalent
Status
Power
Water
To set:
1. Switch the machine OFF by holding the Off button
in until a number or the letter A shows on the
display.
2. Press and release the On button repeatedly until
the number on the display corresponds to the
desired setting.
3. Press and release the Off switch again to return to
the normal control state.
2 - Moderate 3 - Standard
Factory
Setting for
typical water
De-Scale
Off
On
4 - Heavy 5 - Maximum
December 2014
Page 14
A - Automatic
High TDS
Any with
water
conductivity not
less than 10
microSiemens/cm