How It Works - Water Cooled - Scotsman C0530SR-1 Technical Manual

How It Works - Water Cooled

Freeze Cycle. At start up the controller drains and refills the reservoir. The reservoir refills
when the mid length water level sensor probe is uncovered and continues to fill until the top
probe is in contact with water. When the reservoir has filled, the compressor and water pump
start. After the discharge pressure has increased past the set point of the water regulating
valve, the water regulating valve will open and warm water will be discharged out the
condenser drain. The water regulating valve will modulate to maintain a relatively constant
discharge pressure. Water flows over the evaporator as the refrigeration system begins to
remove heat. When the water temperature falls to a preset point, as measured by the water
temperature sensor, the controller shuts off the water pump for 30 seconds. The freeze cycle
resumes when the pump restarts and ice begins to form on the evaporator. As it forms, the
water flowing over the ice moves closer and closer to the metal tip of the ice thickness sensor.
When it comes into contact with the sensor for a few continuous seconds, that signals the
controller that the freeze cycle is complete.
Harvest Cycle. When the harvest cycle begins, the controller switches on the hot gas valve,
and through a parallel circuit, the harvest assist solenoid. After a few seconds the purge valve
opens and water is drained from the reservoir. Based on either the automatic purge or manual
purge setting, the pump and purge valve will be switched off at a time determined to have
drained enough water for that setting. The inlet water valve will open to fill the reservoir
anytime the mid length probe is uncovered, which occurs during the reservoir drain cycle.
Harvest continues as the hot discharge gas flows into the evaporator serpentine, heating up
the evaporator. At the same time the harvest assist solenoid is pushing against the back of the
ice slab. When the ice releases from the evaporator, it harvests as a unit, and the harvest
assist probe provides some additional force to push it off. When the ice falls off it will force the
curtain(s) open. An open curtain during the harvest cycle signals the controller that the
evaporator has released its ice. If this is a single evaporator machine the controller will
terminate harvest. If it is a two evaporator machine, the controller will continue harvest until
both curtains have opened. If a curtain remains open, the controller will shut the machine down
on bin full. Anytime harvest is complete the hot gas valve and harvest assist solenoid are shut
off. The harvest assist solenoid pin returns to its normal position by spring pressure.
If the curtain(s) re-close after harvest, the freeze cycle will restart.
January 2010 Page 25