Ricoh PRO L4130 series Care And Maintenance Manual page 9

Replacing method of absorber kit ("Replacing method of
absorber kit" Chapter 4 of the Operation Manual)
If ink adheres to the absorber, it is required to replace the absorber.
Rough guide for replacement:
Replace when the concavity and convexity of the surface of the absorber
are filled with ink as indicated in the right photo.
In addition, when you replace the absorber, clean ink adhering to the
capping station at the same time.
• To replace the absorber, the absorber kit separately sold is
required. Contact a distributor in your district or our office
for purchasing it.
1
Press the
2
Press the
3
Press
4
Press the
• The carriage moves to the maintenance position.
• If the carriage is not covered by the ink cap for a long period of
time, the nozzle face of the head may get dry and clogged,
resulting in white lines being left in the printed image.
• The buzzer sounds periodically while the carriage is out of the
capping station. The buzzer sounds at shorter interval when the
print heater temperature is high.
5
Open the rght maintenance cover then remove
the absorber.
• Pull out the absorbers (x 4).
6
Insert a new absorber.
• There are two types' absorbers and four in total
(absorber x 1, absorber 2 x 3).
• Be careful not to mess up the positions to which they are
inserted.
key in LOCAL.
MAINT.
key.
to select [STATION MAINT.].
key.
9
Dirty absorber
Dirty absorber
CARR I AGE OU T
MOVE POS I T I ON
: S T A T I ON MA I N T .
MOVE POS I T I ON
: S T A T I ON MA I N T .
Carriage
absorber
absorber2
[ EN T ]