Ricoh PRO L4130 series Care And Maintenance Manual page 7

11
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap rubber cover
with a clean stick dipped in Cleaning Fluid for maintenance.
(Wipe off so that you can see blue color of the cap rubber.)
Wipe off so that Cleaning Fluid for maintenance will not remain.
Before cleaning
12
Press the
13
Close the right maintenance cover then press the
key.
• After its initial operation, the machine returns to step1.
Further, in the cases as explained below, replace the wiper with the new one.
Even if you clean the wiper enough, nozzle clogging etc. occurs frequently
When the wiper is deformed
When the stuck ink can not be wiped off
When the warning for wiper replacement is indicated
When the warning message for replacing wiper is shown, confirm whether
there is no damage and fuzz at the top edge of the wiper film. If there is no
damage on the top edge of the wiper film, it is possible to use the wiper contin-
uously without replacing it.
After cleaning
key after the cleaning.
7
Cap rubber
Cap rubber cover
C l o s e c o v e r
COMP L E T ED [ EN T ]