Ricoh PRO L4130 series Care And Maintenance Manual page 5

4
Press the
• The carriage moves to the maintenance position.
• If the carriage is not covered by the ink cap for a long period of
time, the nozzle face of the head may get dry and clogged,
resulting in white lines being left in the printed image.
• The buzzer sounds periodically while the carriage is out of the
capping station. The buzzer sounds at shorter interval when the
print heater temperature is high.
5
Open the right maintenance cover cover then
remove the wiper.
• Pull out the wiper by holding the protrusions at its both ends.
6
Put the wiper that you used for one day into a provided case or solvent-resistance-
covered-container (glass, earthenware, etc.) and pour Cleaning Fluid.
• Time to immerse the wiper shall be for 1 to 24 hours.
• If you leave the wiper immersed in Cleaning Fluid too long, the wiper may be deformed.
• Dispose the Cleaning Fluid for soaking the wiper if it gets dirty. (As a guide, replace it in a
week). Regarding disposal of unused Cleaning Fluid, please ask Industrial waste disposer
and pursuant to the regulations of your district.
• For case for immersing the wiper, please use provided case or solvent-resistance-covered-
container. In case that you want to immerse the wiper by using your resin case, please
make sure to test whether there are no problems such as case deformation before you try.
7
Take out the wiper and remove ink blot etc. with a
Kimwipe®.
• Wipe off well so that any lint etc. do not remain on the top
edge of the wiper film.
key.
At the start of immersion At the end of immersion
5
Carriage
Projection