Ricoh PRO L4130 series Care And Maintenance Manual page 21

16
Press the
• Start pushing ink out. (The screen to wait for air purge completion is
displayed.)
(1) Ink pushed out flows to the jig.
(2) Flow ink for about 30 sec. after ink started to flow.
(3) After flowing ink for about 30 sec., close the port.
(4) Change the jig to another port, flow ink for about 30 sec. in the
same way.
(5) After flowing ink for about 30 sec., close the port.
17
Press the
• Pushing out ink stops.
18
Close the right maintenance cover.
19
Press the
• The carriage moves to the cap position.
• When the carriage moving has been completed, the air purge start
screen is displayed.
20
Press the
• The screen to check air purge valve CLOSE is displayed.
21
Open the right maintenance cover.
22
Close the air purge valve.
• Using a flat-blade screwdriver, rotate the air purge valve so that the slot of it may be vertical.
23
Close the right maintenance cover.
24
Press the
• Cleaning is performed.
• When cleaning has been completed, the screen returns to [FILL UP
INK] of the maintenance menu.
25
Press
key and perform air purge.
• When removing the jig, ink may leak. Put a paper towel etc. around the port.
key.
key.
key.
key.
the key several times to end the setting.
21
A I R PG
COMP L E T ED
Ink
Reference value :
About 10cm
CA PP I NG POS I T I ON
MOVE S T AR T
P L E A SE WA I T
A I R PG
END < > S T AR T
A I R PG V A L V E C L OS E
COMP L E T ED
* * C L EAN I NG * *
[ EN T ]
[ EN T ]
[ EN T ]