Electrical Connection Safety; Gas Connection Safety; If You Smell Gas; Peculiar Smells - Rangemaster Classic 110 Dual Fuel User's Manual & Installation Instructions

Electrical Connection Safety

A Gas Safe registered engineer should service the cooker
and only approved spare parts should be used.
The electrical installation must be installed in accordance
with all relevant British Standards/Codes of Practice,
BS 7671. Or with the relevant national and local
regulations and with the local gas and electricity supply
companies' requirements.
Otherwise, all installations must be in accordance with
the relevant instructions in this booklet.
Read the instructions before installing or using this appliance.
• This appliance is heavy so take care when moving it.
• The cooker may be installed in a kitchen/kitchen diner
but NOT in a room containing a bath or shower.
• This cooker must be earthed.
• This cooker MUST NOT be connected to an ordinary
domestic power point.
• It is normal for the hob control display to flash for about
2 seconds during first power setting.
• Set the clock to make sure that the oven is functional –
see the relevant section in this manual.
• The appliance must be installed in accordance with the
regulations in force and only in a well ventilated space.
• Failure to install the appliance correctly could invalidate
any warranty or liability claims and lead to prosecution.
• DO NOT install the appliance on a platform.
• DO NOT move the cooker while it is plugged into the
electricity supply.
• Before electrical reconnection, check that the appliance
is electrically safe.

Gas Connection Safety

• This cooker is a Class 2 Subclass 1 appliance.
• This appliance can be converted for use on another gas.
• Before installation, make sure that the cooker is suitable
for your gas type and supply voltage. See the data
badge.
• DO NOT use reconditioned or unauthorised gas
controls.
• Disconnect from the electricity and gas supply before
servicing.
• When servicing or replacing gas-carrying components
disconnect from the gas supply before starting
operation. Check the appliance is gas sound after
completion.
• Make sure that the gas supply is turned on and that the
cooker is wired in and switched on.
• In your own interest and that of safety, it is law that all
gas appliances be installed by a qualified person(s).
• An appliance for use on LPG must not be installed in
a room or internal space below ground level, e.g. in a
basement.
• This cooker must be installed in accordance with:
• British Standards/Codes of Practice, BS 5440 Part 2
• Natural Gas: BS 6172 and BS 6891
• LP Gas: BS 5482-1 (when the installation is in a
permanent dwelling)
• Gas Safety (Installation and Use) regulations
• Relevant Building/IET regulations

If You Smell Gas

• DO NOT turn electric switches on or off
• DO NOT smoke
• DO NOT use naked flames
• Turn off the gas at the meter or cylinder
• Open doors and windows to get rid of the gas
• Keep people away from the area affected
• Call your gas supplier
• If you are using Natural Gas in the UK, ring the
National Grid on: 0800 111 999

Peculiar Smells

When you first use your cooker it may give off an odour. This
should stop after use.
Before using for the first time, make sure that all packing
materials have been removed and then, to dispel
manufacturing odours, turn the ovens to 200 °C and run for at
least an hour.
Before using the grill for the first time you should also turn on
the grill and run for 30 minutes with the grill pan in position,
pushed fully back and the grill door open.
Make sure the room is well ventilated to the outside air
(see 'Ventilation' below). People with respiratory or allergy
problems should vacate the area for this brief period.
2