Non-Option Set Parameters
This section describes parameters that are independent of the option set
selected. Determine whether the default options are correct for your site,
and set parameters as needed.
Table 3-5. Site-Specific Parameters
Parameter
Test Options
Accept RDL
Modulation Options
Guard Tone
EC/DC Options
Buffers
Automatic Call Unit (ACU) Options
Call Progress
3-10
3460 Fast'R
Default Option
AT&T4=On
Country-specific
AT
NB0=Regular
*
Available Option
AT&T5=Off
AT&G0=Off
AT&G1=550
AT&G2=1800
AT
NB1=Reduced
*
ATX0=Modem uses only NO
CARRIER and CONNECT
result codes.
ATX1=Modem uses only NO
CARRIER, CONNECT, and
CONNECT <Rate> result
codes.
ATX2=Modem waits for dial
tone and uses only NO
CARRIER, CONNECT,
CONNECT <Rate> and NO
DIALTONE result codes.
ATX3=Modem detects busy
signal and uses only NO
CARRIER, CONNECT,
CONNECT <Rate>, and
BUSY result codes.