Rear End Door Window Components
1. Rear end door glass
Rear End Door Glass Removal and Installation
Refer to "Windshield Removal and Installation" as
preparation, removal and installation procedures are
basically the same. However, note the following.
• Observe the following precautions when applying
adhesive (1) along glass (2) edge.
• Adhesive (1) should be applied evenly especially in
height.
• Be careful not to damage primer (3).
• Install glass (2) on rear end door panel (5) noting the
following.
– With the position of fastener (4) properly aligned.
– With the position of ceramic mark (6) aligned to the
mark (7) of rear end door panel (5).
• Press glass against body quickly after adhesive (1) is
applied.
Adhesive amount specifications and position for
rear end door glass
Height "a": 13 mm (0.51 in.)
Width "b": 7 mm (0.28 in.)
Width "c": 14 mm (0.55 in.)
Position "d": 15 mm (0.59 in.)
Position "e": 42 mm (1.65 in.)
Position "f": 37 mm (1.46 in.)
Position "g": 9 mm (0.35 in.)
Position "h": 14 mm (0.55 in.)
2
2
S6RW0D9506008
Glass / Windows / Mirrors:
2
1
2. Fastener
"d"
3
"c"
1
2
"a"
"b"
2
"c"
3
1
"h"
"a"
"b"
"A"
1
4
5
2
S6RW0D9506007
I5RW0A950011-02
2
7
5
6
"A"
"B"
"c"
"e"
2
"f"
"a"
3
1
"b"
"g"
"B"
2
4
1
5
I7RW01950010-01
9E-12