Replacement Of Transmitter Battery (Other Than Keyless Start Model); Programming Transmitter Code For Keyless Entry System (Other Than Keyless Start Model) - Suzuki 2006 SX4 Service Manual

9F-13 Security and Locks:
If check result is not as specified, replace switch.
"a" "b"
Replacement of Transmitter Battery (Other than
Keyless Start Model)
NOTE
For keyless start model, perform
"Replacement of Remote Controller Battery
in Section 10E" instead of "Replacement of
Transmitter Battery (Other than Keyless Start
Model)".
If transmitter becomes unreliable, replace transmitter
battery as follows.
1) Remove screw (1) and transmitter cover (2).
2) Remove transmitter (3) from transmitter holder (4).
CAUTION
!
Use care not to allow grease or dirt to be
attached on the printed circuit board and the
battery.
3) With tip of flat blade screwdriver put in slot of
transmitter, pry it open.
4) Replace the battery (lithium disc-type CR 1620 or
equivalent battery) so its (+) terminal faces "+" mark
on transmitter.
5) Fit together transmitter (3) and install it into
transmitter holder (4).
6) Install transmitter cover (2) and screw (1).
1
I5RW0A960009-02
Programming Transmitter Code for Keyless
S6RW0D9606014
Entry System (Other than Keyless Start Model)
If transmitter or BCM (included in junction block
assembly) is replaced with a new one or additional
transmitter(s) is necessary, program transmitter code(s).
7) Make sure that door locks can be operated with
transmitter.
NOTE
• To prevent theft, be sure to break the
transmitter before discarding it.
• Dispose of the used battery properly
according to applicable rules or
regulations. Do not dispose of lithium
batteries with ordinary household trash.
NOTE
• Three transmitter codes can be registered.
• When a new transmitter code is registered,
the oldest one will be cleared.
• As for vehicle equipped with keyless start
system, perform "Registration Procedure
for Remote Controller ID Code in Section
10E" instead of "Programming Transmitter
Code for Keyless Entry System (Other than
Keyless Start Model)".
1) Confirm that all doors are closed and ignition key is
out of ignition key cylinder.
2) Open driver side door.
3) Turn ignition switch to ON position, and then drawn
ignition key from ignition key cylinder within 10
seconds after that.
4) Push and release driver side door switch (1) at 3
times by hand within 20 seconds after removing
ignition key from ignition key cylinder.
5) Turn ignition switch to ON position, and then drawn
ignition key from ignition key cylinder within 10
seconds after that. All doors automatically lock and
unlock once.
With this, registration mode.
4
3
2
1
I4RS0B960014-01
S6RW0D9606015