Rear End Door Window Defogger Relay Inspection; Rear End Door Window Defogger Wire Inspection - Suzuki 2006 SX4 Service Manual

9E-19 Glass / Windows / Mirrors:
Rear End Door Window Defogger Relay
Inspection
1) Disconnect negative (–) cable from battery.
2) Remove junction block for inspection of rear end
door window defogger relay.
3) Remove rear end door window defogger relay (1)
from junction block (2).
3
3. Hood latch release cable
4) Check that there is no continuity between terminal
"c" and "d". If there is continuity, replace relay.
5) Check that there is continuity between terminals "c"
and "d" when a 12 V battery is connected to
terminals "a" and "b".
If malfunction is found, replace it with a new one.
b a
c
d
S6RW0D9506018
2
1
2
I5RW0A950034-01
c
d
a
b
I4RS0A950028-01
Rear End Door Window Defogger Wire
Inspection
NOTE
• When cleaning rear end door window
glass, use a dry cloth to wipe it along heat
wire (1) direction.
• When cleaning glass, do not use detergent
or abrasive-containing glass cleaner.
• When measuring wire voltage, use a tester
with positive probe (2) wrapped with a tin
foil (3) which should be held down on wire
by finger pressure.
Wire Damage Inspection
1) Start engine.
2) Turn on defogger switch.
3) Measure voltage at the center of each defogger wire
(1), and check defogger wire condition according to
the following table.
If defogger wire open is found, go to next step.
Defogger wire voltage
Voltage
0 – 1 V Defogger wire open between its center
and defogger wire power source terminal
end (2)
4 – 6 V Normal condition
10 – 12 V Defogger wire open between its center
and defogger wire ground terminal end
(3)
3
S6RW0D9506019
I2RH01950002-01
Circuit
1
2
I4RS0A950029-01