Gps Antenna Removal And Installation (If Equipped); Horn Removal And Installation; Horn Inspection; Horn Relay Inspection - Suzuki 2006 SX4 Service Manual

9C-20 Instrumentation / Driver Info. / Horn:
GPS Antenna Removal and Installation (If
Equipped)
Removal
1) Remove combination meter cluster panel referring to
step 1) to 4) of "Combination Meter Removal and
Installation".
2) Disconnect GPS antenna connector from navigation
unit referring to "Audio Unit Removal and Installation
(If Equipped)".
3) Remove GPS antenna (1).
1
Installation
Reverse removal procedure.

Horn Removal and Installation

Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
3) Disconnect horn connector (1).
4) Remove horn (2).
2
1
Installation
Reverse removal procedure for installation.

Horn Inspection

1) Disconnect negative (–) cable at battery.
S6RW0D9306027
2) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
3) Disconnect horn connector (1).
4) Connect battery positive (+) to terminal of horn
connector (2) and negative (–) terminal to body
ground.
If horn is not sounding, replace horn.
I5RW0A930022-01

Horn Relay Inspection

1) Disconnect negative (–) cable at battery.
2) Remove junction block.
S6RW0D9306020
3) Remove horn relay (1) from junction block (2).
4) Check that there is no continuity between terminals
"c" and "d". If there is continuity, replace relay.
5) Check that there is continuity between terminals "c"
and "d" when a 12 V battery is connected to
terminals "a" and "b". If malfunction is found, replace
it with a new one.
I7RW01930015-01
d
2
b
a
c
a
c
S6RW0D9306021
2
1
I7RW01930016-01
S6RW0D9306022
1
I4RS0B930018-01
d
b
I3JA01920006-01