Toyota 2006 Sienna Owner's Manual page 274

Replace the battery according to the fol-
lowing procedure:
1. Remove the cover of the controller as
shown.
06 SIENNA_U (L/O 0603)
2. Remove the discharged batteries and
put in the new batteries as shown.
Install the cover.
NOTICE
z Be sure that the positive side and
negative side of the controller bat-
tery should be faced correctly.
z Do not replace the battery with wet
hands. Water may cause rust.
z Do not touch or move any compo-
nents inside of the controller, or it
may interfere with proper operation.
z Be careful not to bend the electrode
of the controller battery insertion.
z Close the battery case securely.
After replacing the battery, check that the
controller operates properly. If the control-
ler still does not operate properly, contact
your Toyota dealer.
2006 SIENNA from March '06 Prod. (OM45443U)
263